In this case, remove the paper clip and turn off the tablet (disconnect the USB cable from it and wait - if it does not turn off after a while, you may need to disconnect the battery). If you see that the preloader has connected, then you have poorly closed the contacts in step 5.
usb 3-2.4.1: New USB device strings: Mfr = 0, Product = 0, SerialNumber = 0 usb 3-2.4.1: New USB device found, idVendor = 0e8d, idProduct = 0003 usb 3-2.4.1: new full-speed USB device number 9 using xhci_hcd Hold the connection so that there is good contact.Ħ) Insert the other end of the USB cable.ħ) You should see in the console that you have a new device connected: To do this, connect the CLK and, for example, the protective cover of the board, as shown in this picture.
The message "Waiting for the bootrom" should appear.ĥ) Using a clip, lock CLK to the ground. We are only interested in the bottom, CLK.ģ) Insert one end of the USB cable into the tablet or PC, no matter where it is.Ĥ) On the PC, run the command "./bootrom-step.sh" ( being in the amonet folder). The back cover is not connected with the filling of the tablet.Ģ) On the left side of the board we find 4 outputs with the inscriptions DAT0, RST, CMD, CLK. Start at the bottom (assuming the camera is at the top) and move up. Also, disconnect from the PC all other android devices, if they are connected.ġ) Use a handy tool to open the back cover of the tablet. If you are told that there are not enough permissions to execute scripts, run them in sudo mode or switch to it for a while using "sudo -s".Ġ) Completely turn off the tablet and disconnect all wires from it. Note: you can unpack the archive from under Windows using Winrar and upload it in unpacked form. We find where you have and unpack it in any place, and then go to the unpacked amonet folder. Sudo apt install python3 serial python3 android-tools-adb android-tools-fastboot Launch Linux (Ubuntu / LiveCD) and install Python3, PySerial, adb and fastboot using the command from the console: hd8-exploit.zip file ( download), which includes: something conductive, for example, a piece of wire or a clip. than you can pry and open the lid of the tablet. The instruction for Windows is not ready yet and was not checked. Linux distribution (for example, Ubuntu, go and LiveCD). You also need to enable USB debugging in the developer options. It is advisable to make sure that you do not enable device encryption - if so, turn it off before starting work. This method is suitable for both 16GB and 32GB versions of the tablet.īefore you begin, make sure that you save all the data you need from the tablet, as they will be completely erased in the process. This instruction is only suitable for HD 8 (2018), the internal name is karnak, model KFKAWI. You will need to open the back cover of the tablet, but no special devices or soldering are required. Before starting any action, read the entire manual.
0 kommentar(er)
